For 'OO' 'HO' and 'N' gauge layouts.

State-of-the-art design,electronics,and construction, offer the very best in performance and capability.

Each 220/240 volts AC mains-powered controller, is designed with twin transformers, to supply correct voltage to each track.Automatic re-set 1.1 amp circuit breakers protect against overload.Mains lead of 1.5mtrs long. 

Unique to Morley,the Vector controller is designed with an on-board points Capacitor Discharge Unit (CDU).When used with a correct switch it will activate the points motor,giving it a firm,positive,short burst of current,being of short duration it prevents motor burn out.A "points CDU ready" yellow LED indicator is situated on the front panel.

The screen-printed front panel gives perfect indication of the settings of switches and controls,supported by LED indicators,a dual LED for power and direction, plus the CDU LED.

Centre off power controls ,provide locomotive direction change,together with perfect smooth control at slow speeds,as well as fast.

A 12 Volt uncontrolled accessory output is provided, with protection from a 1 amp circuit breaker.

Two hand held units are included, with centre off controls providing power and direction change.The length of cable is 2.5 mtrs.

Output connections are by a Screw Type PCB Terminal Block.

Desk type dark grey case with sloping aluminium front.

Fully tested and guaranteed for 5 years.

Our controllers do not have any form of feedback.

We manufacture in the UK.RoHS Compliant.Based on the information provided by our component manufacturers,the Vector does NOT contain the substances restricted by the RoHS legislation at levels over the maximum concentration values.

Technical specification:

• Twin track controller manufactured from quality components tested to 105 degrees centigrade.
• Suitable for N, 00 and almost all small gauge systems.
• Input: 220/240 volts AC mains. 
• Output: 2 x 12 volts DC at 1.1 amps protected,both controlled. 1 x 12 volts DC accessory protected by 1 amp circuit breaker, uncontrolled.
• Locomotive direction change by centre off power control. 
• On-board Capacitor Discharge Units (CDU) for points motor operation.
• European mains plug optional,no charge. 
• Dimensions: 215mm wide x 130mm height x 75mm deep.

       £65.00  + £4.80 p&p    (£69.80 Total) UK

     (Overseas at cost)